AUTONET TV

Not So Cool (Air Conditioning Systems)

There's nothing quite like getting in your vehicle on a hot day, switching on the air conditioning and having warm air blow out of the vents.  You may have had no problem for months and then, one day, you are driving around in a sauna. You're hot stuff, but not in a good way!

So what goes wrong when the AC isn't working? It could be a lot of things because the system has many different components.  One thing that's a common cause is the vehicle is low on refrigerant (it used to be called Freon).  If that's the case, it's not as simple as simply adding more.  Sure, it may fix it quickly for a short time, but it's more likely than not that the refrigerant will just leak out again.

The original Freon used in air conditioners was destroying the Earth's ozone layer, so that's not used much any more.  But the one that's currently used also contributes to global warming, so it's important that as little of that escapes as possible.  So a technician will determine if there's a leak in your system, where it is and fix that before adding new refrigerant. 

Your vehicle also has an evaporator or two, and those can fail.  Leaks are often the problem with them as well.  The big component that can go bad is the compressor, often a victim of age, wear or neglect. 

A technician will also check to see that the blower is working correctly.  That's what blows that cool air into the cabin.  Sometimes the motor will fail, a relay will go bad or a fuse will blow.  As you can see, there are lots of different parts involved here! 

The good news is that your vehicle's service facility has the special equipment to recover the refrigerant and check the system's pressure, both vital to properly servicing the air conditioning system.

As with many vehicle components, regular maintenance can go a long way to minimizing problems in the air conditioning system. It can reduce the chance of the compressor having to be replaced, too.  Pretty cool, huh?

Westmoreland Transmissions
2001 E LOOP 820 S STE 19A
FORT WORTH, TX 76112
817.466.7295
http://www.westmorelandtransmissions.com

A Bright Spark (Ignition Coil Replacement)

Ever wonder how your vehicle’s engine is able to take the 12-volts from its battery and ramp that up to as high as the tens of thousands of volts it takes to fire its spark plugs? The secret is something called an ignition coil.  Most newer vehicles have an ignition coil at each cylinder, but older ones have a coil that serves all of the spark plugs. 

There are telltale signs that you have an ignition coil problem.  As you might expect, one symptom is it’s hard to start your engine or it won’t start at all.  If your engine is misfiring or not running smoothly or you see the Check Engine light come on, those all could point to an ignition coil failure.

Several things can contribute to ignition coil trouble in addition to normal wear and tear. Moisture and dirt may have gotten inside the coil, plus the heat and vibration of your engine over time can contribute to them going bad.  Bad spark plugs or plug wires can also be a cause.  

While ignition coils can last 100,000 miles/160,000 km, depending on how you drive and in what conditions.  If you start noticing some of the signs and symptoms just described, it’s a good idea to schedule a visit to see us so a technician can diagnose what’s wrong. Driving too long with an engine misfiring can damage your catalytic converter, and that can be expensive to replace.

A technician will thoroughly check your ignition system and determine where the failure is.  If it’s only one coil that’s bad, it may be the only thing that will need replacing.  If your vehicle has a distributor, it may also need to be replaced.  Properly-working ignition coils will help your vehicle operate at its best and help prevent future engine damage.

Westmoreland Transmissions
2001 E LOOP 820 S STE 19A
FORT WORTH, TX 76112
817.466.7295
http://www.westmorelandtransmissions.com

Wired! (Battery Cable Service)

Colder weather brings out the worst in a vehicle's battery.  On a very cold day, you may have experienced that your engine cranks slowly when starting.  But while it may be the battery itself, it may also be the parts that transfer the power to other the other electrical components, the battery cables.  After all, you have to have some way to get the current out of the battery and out to where it needs to go.

Battery cables have a couple of enemies: corrosion and age.  You may have looked under the hood and noticed a light-colored powder or crust around the terminals.  That's what happens when acids corrode the ends of the battery terminals.  Corrosion inhibits the connection and may reduce the amount of power getting to the electrical accessories to the point where they are not working correctly, if at all.

Here are some symptoms of problems with your battery cables. You might notice a clicking sound when you turn the key, some of your vehicle's electrical parts (like the sound system or the horn) don't work or, in some cases, the vehicle won't start at all.

When you take your vehicle to a repair facility, the technician will use instruments to check voltages to see how much current is getting to what location. That includes a starter draw test during which the battery's voltage is checked when the starter is cranked.  The technician will also visually inspect the cables and the charging system. To make sure the alternator is putting out the right voltage, the technician will measure that as well. 

If the problem is found to be the battery cable assembly, the entire set may have to be replaced. Sometimes they can be repaired. 

During the colder months, it's vital that your vehicle has the proper power going to its electrical components.  Having a vehicle that won't start or run smoothly is not something you want to battle with when you're already up against challenging weather.  Keep your electrons flowing… and your vehicle moving.

Westmoreland Transmissions
2001 E LOOP 820 S STE 19A
FORT WORTH, TX 76112
817.466.7295
http://www.westmorelandtransmissions.com